FluidNC Alarm 7

FluidNCAlarmPosition isn't set yet: home first

The safety door was opened during homing.

Position isn't set yet: home first. Homing didn't finish. (Hamrun's reading)
What to do
  1. Close the door (or check the door switch input), then home again.
Official FluidNC message: “Homing Fail Door” source

Got a different message?

Paste it into the decoder. Hamrun's editor checks your G-code before you run it, so a toolpath that leaves the machine's travel or a missing feed rate is caught before the machine stops. Have the whole file? Check it here, free: it finds the line that triggers this, and the file never leaves your computer.

Related codes

Official text copied from the FluidNC source on 2026-11-01. Steps and the position answer are Hamrun's reading unless marked “firmware says”. User reports are labelled CLAIMED.