uCNC Alarm 15
uCNCAlarmNot a position problem
Something went wrong during an automatic tool change.
Not a position problem. Hamrun's reading: it depends on where the change stopped. Check the tool, then home before trusting position. (Hamrun's reading)
What to do
- Look at the tool changer: is a tool half-dropped, or the rack out of place?
- Check the tool number in the file exists in your tool table.
- Home the machine, then set your work zero again before restarting the job.
Name in the uCNC source:
EXEC_ALARM_ATC_ERROR. The meaning above is in Hamrun's words; uCNC's own message text isn't copied here. sourceGot a different message?
Paste it into the decoder. Hamrun's editor checks your G-code before you run it, so a toolpath that leaves the machine's travel or a missing feed rate is caught before the machine stops. Have the whole file? Check it here, free: it finds the line that triggers this, and the file never leaves your computer.
Code name taken from the uCNC source on 2026-11-10; the meaning is in Hamrun's words and uCNC's message text isn't copied. Steps and the position answer are Hamrun's reading unless marked “firmware says”. User reports are labelled CLAIMED.