uCNC Alarm 14

uCNCAlarmPosition is kept

The plasma torch's arc didn't start when the torch height control asked for it.

Position is kept. Hamrun's reading: the arc never started, so the machine stopped before cutting. (Hamrun's reading)
What to do
  1. Check the consumables (tip and electrode), the air pressure and the ground clamp on the work.
  2. Check the arc-OK signal from the plasma cutter is wired to the controller.
  3. Reset and run the cut again.
Name in the uCNC source: EXEC_ALARM_PLASMA_THC_ARC_START_FAILURE. The meaning above is in Hamrun's words; uCNC's own message text isn't copied here. source

Got a different message?

Paste it into the decoder. Hamrun's editor checks your G-code before you run it, so a toolpath that leaves the machine's travel or a missing feed rate is caught before the machine stops. Have the whole file? Check it here, free: it finds the line that triggers this, and the file never leaves your computer.

Code name taken from the uCNC source on 2026-11-10; the meaning is in Hamrun's words and uCNC's message text isn't copied. Steps and the position answer are Hamrun's reading unless marked “firmware says”. User reports are labelled CLAIMED.