Grbl_Esp32 Error 24

Grbl_Esp32ErrorPosition is kept

Two commands on one line both want the X/Y/Z values, so the controller can't tell which gets them.

Position is kept. An error means the controller refused that one line or command, so nothing moved for it. (Hamrun's reading)
What to do
  1. Split the line so each motion command is on its own line.
  2. Check the post-processor matches your controller.
Name in the Grbl_Esp32 source: GcodeAxisCommandConflict. The meaning above is in Hamrun's words; Grbl_Esp32's own message text isn't copied here. source

Got a different message?

Paste it into the decoder. Hamrun's editor checks your G-code before you run it, so a toolpath that leaves the machine's travel or a missing feed rate is caught before the machine stops. Have the whole file? Check it here, free: it finds the line that triggers this, and the file never leaves your computer.

Related codes

  • GRBL 1.1 Error 24: Two commands on one line both want the X/Y/Z values, so the controller can't tell which gets them.
  • grblHAL Error 24: Two commands on one line both want the X/Y/Z values, so the controller can't tell which gets them.
  • FluidNC Error 24: Two commands on one line both want the X/Y/Z values, so the controller can't tell which gets them.
  • uCNC Error 24: Two commands on one line both want the X/Y/Z values, so the controller can't tell which gets them.

Code name taken from the Grbl_Esp32 source on 2026-11-10; the meaning is in Hamrun's words and Grbl_Esp32's message text isn't copied. Steps and the position answer are Hamrun's reading unless marked “firmware says”. User reports are labelled CLAIMED.