Grbl_Esp32 Alarm 10
Grbl_Esp32AlarmNot a position problem
The spindle controller reported a problem.
Not a position problem. Hamrun's reading: FluidNC doesn't say. If it stopped mid-cut, home before trusting position. (Hamrun's reading)
What to do
- Check the spindle or VFD is powered and its cable is connected.
- Check the spindle section of your FluidNC config file.
Name in the Grbl_Esp32 source:
SpindleControl. The meaning above is in Hamrun's words; Grbl_Esp32's own message text isn't copied here. sourceGot a different message?
Paste it into the decoder. Hamrun's editor checks your G-code before you run it, so a toolpath that leaves the machine's travel or a missing feed rate is caught before the machine stops. Have the whole file? Check it here, free: it finds the line that triggers this, and the file never leaves your computer.
Related codes
- FluidNC Alarm 10: The spindle controller reported a problem.
Code name taken from the Grbl_Esp32 source on 2026-11-10; the meaning is in Hamrun's words and Grbl_Esp32's message text isn't copied. Steps and the position answer are Hamrun's reading unless marked “firmware says”. User reports are labelled CLAIMED.