Grbl_Esp32 Alarm 1
Grbl_Esp32AlarmPosition is lost: home again
A limit switch was hit while the machine was moving, so the controller stopped dead.
Position is lost: home again. The stop is instant, so the motors can skip steps. (Hamrun's reading)
What to do
- Look at which axis is sitting on its switch, and why: a job too big for the bed, or a work zero set too close to the edge.
- Reset the controller, then unlock ($X) and jog the machine off the switch.
- Home the machine, then set your work zero again before restarting the job.
- If the switch triggers when nothing touches it, check its cable for a pinch, loose plug or a cable chain pressing on it.
What users reported CLAIMED · forum and issue reports, not official
- Repeated Alarm 3 and Error 9 mid-cut on a 3018 Pro. First blamed on electrical noise; the real cause was the cable chain nudging the Z limit switch. (one owner's report) r/hobbycnc thread, Jul 2026
Name in the Grbl_Esp32 source:
HardLimit. The meaning above is in Hamrun's words; Grbl_Esp32's own message text isn't copied here. sourceGot a different message?
Paste it into the decoder. Hamrun's editor checks your G-code before you run it, so a toolpath that leaves the machine's travel or a missing feed rate is caught before the machine stops. Have the whole file? Check it here, free: it finds the line that triggers this, and the file never leaves your computer.
Related codes
- GRBL 1.1 Alarm 1: A limit switch was hit while the machine was moving, so the controller stopped dead.
- grblHAL Alarm 1: A limit switch was hit while the machine was moving, so the controller stopped dead.
- FluidNC Alarm 1: A limit switch was hit while the machine was moving, so the controller stopped dead.
- uCNC Alarm 1: A limit switch was hit while the machine was moving, so the controller stopped dead.
Code name taken from the Grbl_Esp32 source on 2026-11-10; the meaning is in Hamrun's words and Grbl_Esp32's message text isn't copied. Steps and the position answer are Hamrun's reading unless marked “firmware says”. User reports are labelled CLAIMED.